Adaptador M.2 interno DeLOCK 62591

This Delock Internal M.2 Adapter (model 62591) allows installation of an mSATA module in either half-size or full-size format and connects it to a system via an M.2 (NGFF) interface. With compact dimensions of 80 mm width and 31.5 mm depth, the adapter provides a space-saving solution for adding mSATA storage to systems with an M.2 slot.

Advantages

The adapter supports standard mSATA modules and fits into M.2 NGFF slots, enabling reuse of existing mSATA drives in M.2-capable systems. Its compact footprint makes it suitable for small form-factor systems, and the design preserves the original mSATA connector pinout for compatibility.

Suitable for

• Upgrading storage in desktop PCs with available M.2 (NGFF) slots
• Adding mSATA drives to small form-factor or embedded systems
• Reusing existing mSATA modules in modern M.2-equipped motherboards

Key specifications

• Manufacturer: DELOCK
• Model: 62591
• Interfaces: mSATA (host) to M.2 (NGFF) output
• Supported module sizes: half size and full size mSATA
• Dimensions: 80 mm (W) x 31.5 mm (D)
• Category: HDD and SSD disks accessories
• EAN: 4043619625918

How to use

Install an mSATA module into the adapter following the module alignment and connector orientation. Secure the module if mounting points are provided, then insert the adapter into an available M.2 (NGFF) slot on the motherboard. Ensure the system is powered off and disconnected from mains before installation. After physical installation, power on the system and verify the drive is detected in the BIOS/UEFI or operating system storage management tools.

Recommendations

Use this adapter in systems that support mSATA via an M.2 slot; check motherboard documentation for compatibility and M.2 keying. Keep firmware and drivers up to date and use appropriate mounting to prevent mechanical stress on the module and connector.