Aplique de pared exterior Philips myGarden 172963016 LED 6W, bombilla no reemplazable, negro/blanco, carcasa de resina, 214×78 mm

Philips myGarden 172963016 is an outdoor wall light with an integrated non-changeable LED (6 W) designed for exterior wall mounting. The luminaire combines a black and white resin/synthetics housing with a compact form factor (214×78×214 mm) to provide diffuse warm white illumination for porches, pathways and façades. It operates from AC 220–240 V at 50 Hz and delivers efficient lighting with a rated luminous output and long operating life typical of Philips LED solutions.

Advantages

The integrated 6 W LED ensures low energy consumption compared with traditional lamps while providing steady warm white light suitable for outdoor environments. The resin/synthetics housing and IP44 weather protection make the fixture resistant to rain and splashes, and the fixed-bulb design reduces maintenance by eliminating the need for frequent lamp replacement. Compact dimensions and a neutral black/white finish allow unobtrusive mounting on a variety of exterior surfaces.

Suitable for

Key specifications

How to use

Install the Philips myGarden outdoor wall light on a suitable exterior wall surface following local electrical codes. Ensure the mains supply is switched off before wiring and connect the fixture to an AC 220–240 V, 50 Hz supply. Secure the housing to the wall with appropriate fasteners for the substrate and seal any mounting points if required to maintain weather protection. Once installed, switch on the supply to operate the integrated LED; no lamp replacement is required during the expected service life.

Recommendations

For reliable performance, mount the light at a height and angle that provide even coverage for the intended area and avoid direct exposure to strong jets of water. Use a qualified electrician for installation and follow local regulations. Periodically clean the housing with a damp cloth to remove dirt while ensuring the power is disconnected before maintenance.