AOC CBO QSFP-100G-AOC-10M 10 m Cable óptico activo para redes 100G QSFP+

AOC CBO QSFP-100G-AOC-10M is a 10-metre Active Optical Cable engineered for 100G QSFP+ networks. The cable provides a factory-terminated optical link between QSFP+ ports, enabling short-reach 100 Gigabit connections with low latency and reduced susceptibility to electromagnetic interference. Designed for use in data centres and high-density rack environments, this 10 m AOC delivers a compact, lightweight alternative to copper twinax for high-bandwidth interconnects.

Advantages

The Active Optical Cable combines optical transmission with QSFP+ compatibility to offer high bandwidth and signal integrity over a 10 m reach. Its factory-terminated design simplifies installation and reduces on-site termination errors. Compared with equivalent copper solutions, the AOC reduces weight and heat dissipation while maintaining consistent performance for switch-to-switch and server-to-switch links in congested racks.

Suitable for

• Data centre top-of-rack and spine interconnects
• Server-to-switch and switch-to-switch 100G links
• High-density network equipment installations where cable management and airflow are important
• Short-reach 100G connections requiring low latency and immunity to EMI

Key specifications

• Connector type: QSFP+ to QSFP+ active optical assembly
• Data rate: 100 Gigabit per second link capability
• Length: 10 metres
• Transmission medium: multimode optical active cable
• Latency: low propagation delay suitable for high-performance networking
• Operating environment: designed for rack and data centre deployment
• Form factor: compact cable assembly for high-density ports

How to use

Install the AOC by inserting each QSFP+ connector into corresponding QSFP+ ports on network switches or servers until the latch engages. Ensure port compatibility and that devices are powered down or follow hot-plug procedures recommended by the equipment manufacturer. Route the cable to avoid sharp bends and mechanical strain, maintaining recommended bend radii to preserve optical performance. No additional transceivers or fibre patching are required because the cable is factory-terminated and ready for immediate use.

Recommendations

For reliable operation, verify QSFP+ port support for active optical assemblies and confirm firmware or driver compatibility if applicable. Maintain tidy cable management to optimize airflow in racks and avoid tight bends or crushing. Use the 10 m AOC where short-reach, high-bandwidth links are needed and consider longer AOC alternatives if equipment layout requires greater separation.