Cable de fibra óptica InfiniBand BlueOptics 740-060381-BO 30 m QSFP aguamarina

The BlueOptics 740-060381-BO InfiniBand fibre optic cable 30 m QSFP Aqua is a 30-metre active optical cable (AOC) with QSFP-to-QSFP male connectors designed for high-speed data transmission in data centers and networking environments. It follows MSA-compliant QSFP standards and supports multi-mode optical links for up to 40 Gbit/s over the supplied 30 m length. The cable integrates transmitter and receiver electronics on each end to handle optical signaling and is intended for use with hardware platforms that accept QSFP AOC modules.

Advantages

The cable provides a factory-terminated optical connection that eliminates the need for field splicing or patchcord cleaning, reducing installation time and sources of attenuation. Its QSFP-to-QSFP design supports simultaneous send and receive optical channels and is suitable for low-latency, high-throughput applications. The BlueOptics product is manufactured to industry MSA standards and uses proven optical and electronic components, which contributes to predictable operation and extended service life.

Suitable for

• High-speed server-to-switch and switch-to-switch links in data centers
• Storage system interconnects requiring 40 Gbit/s multi-mode links
• Low-latency InfiniBand and Ethernet applications inside racks and between adjacent racks

Key specifications

• Function: Active optical cable (AOC) with integrated Tx/Rx electronics
• Connector type: QSFP (QSFP-to-QSFP, male/male)
• Length: 30 metres
• Transmission medium: Multi-mode fiber
• Supported data rate: up to 40 Gbit/s over the 30 m link
• Digital diagnostics support: DOM/DDM (compliant with common SFF MSA specifications where hardware supports it)

How to use

Install the BlueOptics QSFP AOC by inserting each QSFP connector into the corresponding QSFP port on your network devices while both devices are powered or according to vendor guidance for hot-pluggable modules. Ensure the connected devices officially support QSFP AOC links and, if you require real-time diagnostic data, verify that the host hardware exposes DOM/DDM information. After insertion, confirm link status and speed via the device management interface and monitor the connection for expected operation.

Recommendations

Route and secure the 30 m cable to avoid tight bends and mechanical strain; maintain the minimum bend radius specified by the manufacturer and keep the cable clear of sharp edges and heat sources. For reliable DOM/DDM readings and compatibility, use the cable with devices that support QSFP AOC modules and follow the host vendor’s instructions for firmware and port configuration.