AOC CBO QSFP-100G-AOC-10M cable óptico activo, 10 m, QSFP+ a QSFP+

AOC CBO QSFP-100G-AOC-10M active optical cable is a 10‑metre QSFP+ to QSFP+ link engineered for 100G connectivity in modern data centre environments. This active optical cable provides a direct, low-latency 100 Gigabit connection between QSFP+ ports on switches, routers and servers without the need for separate optical transceivers. The plug-and-play design simplifies installation, reduces rack power draw compared with transceiver-based links and supports short-reach interconnect topologies where high bandwidth and signal integrity are required.

Advantages

The cable delivers consistent 100G throughput with reduced electromagnetic interference typical of optical links. By integrating active optics into the cable assembly, it eliminates compatibility issues and spare-part management associated with separate transceivers. Its 10 m length provides flexibility for inter-rack and intra-row connections while lowering total power consumption and cooling requirements. The QSFP+ to QSFP+ form factor ensures straightforward compatibility with devices that support standard 100G QSFP+ ports.

Suitable for

• High-speed uplinks between core and aggregation switches
• Direct server-to-switch 100G connections in compute racks
• Short-reach links inside data halls and between adjacent racks
• Hyperscale and enterprise deployments requiring predictable latency

Key specifications

• Connector type: QSFP+ to QSFP+
• Data rate: 100 Gbit/s aggregate
• Length: 10 metres
• Type: Active optical cable (AOC) with integrated transceiver electronics
• Signal characteristics: Low latency, optical transmission for EMI immunity
• Power: Lower power draw compared with discrete pluggable transceiver plus copper cable solutions

How to use

Install the cable by connecting each QSFP+ end into the corresponding QSFP+ port on your network equipment until the latch clicks into place. The cable is plug-and-play; connected devices typically detect the link automatically and negotiate 100G operation. Ensure both ports support QSFP+ 100G signalling and check device firmware or configuration for any required port enabling. Route the cable to avoid sharp bends and secure it to prevent strain on the connectors during operation.

Recommendations

For reliable performance, use the AOC for short-reach interconnects up to 10 m within racks or between adjacent racks. Verify compatibility with your switch or server vendor's QSFP+ port specifications and keep device firmware updated. Avoid tight bending radii and excessive mechanical stress; store and handle the cable by the connector housing where possible.