AOC CBO SFP-AOC-10G-30M LinkSys Cable óptico activo 10G, 30 m, SFP+

The AOC CBO SFP-AOC-10G-30M LinkSys 10G Active Optical Cable, 30 m, SFP+ is a factory-terminated fiber direct-attach solution for 10 Gigabit Ethernet links. It integrates SFP+ connectors with a 30-meter optical assembly to provide low-latency, low-power connectivity between servers, switches and storage devices. The cable is intended for short-reach data center interconnects and provides a reliable 10G physical layer without the need for separate transceivers and fiber patch cords.

Advantages

This active optical cable combines the compact form factor of SFP+ connectors with the signal integrity of optical fiber to deliver consistent 10G throughput over a 30 m span. The integrated design reduces installation complexity and port density impact compared with discrete transceivers plus patch cables, while consuming less power than equivalent copper direct-attach alternatives. It offers predictable latency and immunity to electromagnetic interference, suitable for dense rack and spine/top-of-rack topologies.

Suitable for

• 10 Gigabit Ethernet links between switches and aggregation devices in data centers
• Server-to-switch or server-to-storage connections requiring short-reach 30 m links
• Spine-and-leaf and top-of-rack deployments where low power and low latency are important
• Network upgrades that prefer integrated SFP+ active optical assemblies for simplified cabling

Key specifications

• Data rate: 10 Gbit/s (per link)
• Connector type: SFP+ on both ends
• Cable type: Active optical assembly (AOC)
• Length: 30 meters
• Contacted medium: multimode optical fiber with integrated transceivers
• Typical use environment: data center short-reach interconnects
• Power consumption: lower than comparable copper direct-attach cables (typical for AOC designs)

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ ports on your network devices until the latch engages. Ensure devices are powered off or that hot-swapping is supported by your equipment before insertion or removal. After physical installation, verify link status and negotiated speed in the device management interface. No separate transceiver module or fiber patching is required; the assembly is factory-terminated and ready for immediate use.

Recommendations

Use the cable in appropriate SFP+ ports rated for active optical assemblies and observe manufacturer guidelines for hot-plugging, bend radius and ambient temperature. Avoid sharp bends and excessive pulling force on the fiber assembly; route the cable within data center cable management paths to prevent stress. Confirm compatibility with your switch or server vendor if firmware-based port restrictions are in place.