BlueOptics BTI-SFP+-XBD40L-DD-33/27S-BO Módulo transceptor de red de fibra óptica 10000 Mbit/s SFP+

The BlueOptics BTI-SFP+-XBD40L-DD-33/27S-BO is a compact fiber optic SFP+ transceiver module for 10 Gbit/s (10000 Mbit/s) links. It uses an SFP+ form factor with an LC simplex optical interface and is designed for singlemode fiber connections. The module supports separate transmit and receive wavelengths suitable for long-reach single-fiber applications and is built to industry MSA mechanical and electrical standards. With a lightweight silver housing and a rated MTBF of 1,000,000 hours, the transceiver is intended for installations where reliable, high-speed optical connectivity is required.

Advantages

The module provides 10G transmission in a standardized SFP+ package, enabling easy hot-plug replacement in compatible network equipment. Its LC simplex interface allows point-to-point singlemode fiber deployment with independent TX and RX wavelengths. Manufactured to MSA guidelines, the transceiver is compatible with a wide range of switches, routers and storage devices that accept SFP+ optics and supports digital diagnostics monitoring for real-time status information. The small form factor and light weight simplify installation in dense rack environments.

Suitable for

Key specifications

How to use

Install the transceiver into an SFP+ slot on a compatible switch, router or storage device while the host interface is powered down or following the vendor’s hot-plug procedures. Connect an LC simplex singlemode fiber patch cable to the module’s optical port, observing correct orientation for transmit and receive fibers as required by the link design. Verify link status on the host device and, if supported, read digital diagnostic monitoring values to confirm optical power, supply voltage and temperature are within expected ranges.

Recommendations

Ensure the host equipment explicitly supports MSA-compliant SFP+ modules and that the link design matches the module’s singlemode LC simplex configuration and wavelengths. Use high-quality singlemode patch cables and maintain clean connector endfaces to preserve signal integrity. If digital diagnostics are required, confirm that the system firmware exposes DDM/DOM parameters. Follow manufacturer guidelines for insertion/removal and electrostatic precautions during handling.