Cable AOC CBO SFP-AOC-10G-3M 10G cable óptico activo, longitud 3 m

The AOC cable CBO SFP-AOC-10G-3M 10G active optical cable, 3 m length is a pre-terminated, factory-tested fiber interconnect designed to provide a direct, low-latency 10 Gigabit link between SFP+ ports. This 3 metre active optical cable combines transceiver and fiber in a single compact assembly to eliminate the need for separate SFP+ transceivers and patch cords. It is intended for use in data center and enterprise network environments where reliable high-speed connectivity between switches, servers and storage systems is required.

Advantages

The cable delivers 10G data rates with reduced power consumption compared with separate transceiver plus fiber solutions and minimizes electrical interference because the signal is carried optically. As a pre-terminated active assembly it reduces installation time and potential connector mismatches, and its compact form factor helps conserve rack and port space. Factory testing ensures link integrity and consistent performance for short-reach interconnects.

Suitable for

• Direct server-to-switch or switch-to-switch 10G connections within racks and across adjacent racks
• Top-of-rack and middle-of-row high-speed interconnects in data centres
• Connecting storage arrays or NAS devices to 10G-capable network interfaces
• Environments requiring low-latency, electrically immune links in short-reach deployments

Key specifications

• Data rate: 10 Gigabit per second (10G)
• Length: 3 metres
• Connector type: SFP+ direct-attach active optical assembly
• Transmission medium: optical (active optical cable)
• Zero electrical crosstalk and immunity to electromagnetic interference
• Pre-terminated, hot-pluggable design for SFP+ ports

How to use

Install the AOC by inserting each SFP+ connector into the corresponding SFP+ port on your network devices until the module latches. No separate transceivers or patch cables are required. Verify link status through device LEDs or network management interfaces. For replacement or relocation, power down ports only if required by your equipment vendor; otherwise hot-plug removal and insertion are supported by most SFP+ host interfaces. Ensure the cable length and routing avoid excessive bending or strain on the connectors.

Recommendations

Route the cable using appropriate cable management to maintain the manufacturer’s minimum bend radius and prevent mechanical stress on the connectors. Use in short-reach links up to 3 metres as specified; for longer distances, choose suitable fiber transceiver and patching solutions. Confirm device compatibility with SFP+ active optical assemblies in vendor documentation before deployment.