Cable AOC SFP+ CBO SFP-AOC-10G-30M — 10 Gbit/s, 30 m cable óptico activo

The BlueOptics SFP+ AOC cable CBO SFP-AOC-10G-30M is an active optical cable that provides a direct 10 Gbps connection over a 30 meter distance. Designed for SFP+ ports, this cable establishes high-speed links between switches, servers and storage devices while reducing electromagnetic interference and maintaining low latency. The integrated transceivers and optical fiber eliminate the need for separate SFP+ modules and patch cords, simplifying installation in data center and enterprise networking environments.

Advantages

This active optical cable supports 10 Gbps line rate and offers consistent performance over a 30 m reach with low power consumption. The plug-and-play SFP+ form factor ensures compatibility with standard SFP+ ports and minimizes cabling complexity. Optical transmission removes susceptibility to electromagnetic interference, enabling reliable signal integrity in dense rack environments. The integrated design reduces the number of components to manage and can lower overall cabling footprint and heat generation compared with copper alternatives.

Suitable for

• Server-to-switch and switch-to-switch 10 Gbps connections within racks and across adjacent rows
• High-density data center interconnects where reduced electromagnetic interference is required
• Storage area network links and aggregation connections in enterprise networks

Key specifications

• Data rate: 10 Gbps (full duplex)
• Maximum reach: 30 meters
• Form factor: SFP+ active optical cable (integrated transceivers)
• Transmission medium: multimode optical fiber within AOC assembly
• Latency: low optical link latency suitable for data center use
• Power: low power consumption compared with active copper solutions
• Connector type: SFP+ compatible plug on both ends

How to use

Insert each SFP+ connector end into the corresponding SFP+ port on the devices to be linked, ensuring correct seating and latch engagement. The cable is hot-pluggable and requires no separate module installation or fiber patching. After connection, verify link status and speed on connected network equipment and configure ports as needed for 10 Gbps operation. For best results, route the cable to avoid sharp bends and excessive tensile stress on the assembly.

Recommendations

Install the cable in environments that meet standard data center temperature and airflow guidelines. Avoid tight bends near the connector ends and secure the cable to prevent strain. Use the SFP+ AOC for short-to-medium reach links where optical isolation from EMI is beneficial and when you want a compact, low-power alternative to separate transceivers and fiber patch cords.