Cable óptico activo AOC CBO QSFP-100G-AOC-10M 100G, 10 m

The AOC CBO QSFP-100G-AOC-10M active optical cable delivers 100 Gbps connectivity over a 10 metre link. Engineered for short-reach 100G interconnects, this BlueOptics cable connects QSFP-enabled switches, servers and network devices while providing low latency and immunity to electromagnetic interference. Its factory-terminated QSFP connectors simplify installation and eliminate the need for separate transceivers, making it suitable for dense data centre topologies and high-throughput aggregation links.

Advantages

This active optical cable provides consistent 100 Gbps throughput across a 10 m distance with lower power and reduced heat compared with equivalent copper twinax solutions. The AOC design offers improved signal integrity, minimal insertion loss and resistance to EMI, which helps maintain packet fidelity in congested rack environments. Built-in optical transceivers in the cable ends reduce component count and speed up deployment while offering reliable, low-latency performance for latency-sensitive applications.

Suitable for

• Short-reach 100G connections between switches in data centre racks
• Server-to-switch links requiring QSFP ports and 10 m reach
• High-density aggregation and spine-leaf network fabrics
• Environments where electromagnetic interference must be minimized

Key specifications

• Data rate: 100 Gbps
• Length: 10 metres
• Connector type: QSFP (factory-terminated on both ends)
• Cable type: Active optical cable (AOC)
• Typical latency: low, suitable for latency-sensitive links
• EMI performance: immune to electromagnetic interference compared with copper

How to use

Install the cable by inserting the QSFP connectors into the corresponding QSFP ports on source and destination devices while the systems are powered according to vendor guidance. No separate transceivers or additional configuration are required in most environments; the endpoints should automatically detect the link and negotiate 100G operation if supported. Route the cable to avoid sharp bends and protect the optical assemblies from mechanical stress during installation and maintenance.

Recommendations

For optimal performance, use this 10 m AOC within rack or across adjacent rows where QSFP ports are available. Ensure proper airflow and secure cable management to avoid bend radii violations and reduce strain on connector housings. Verify device compatibility with QSFP 100G native ports and check firmware or driver requirements for link training if necessary.