Cable óptico activo (AOC) CBO SFP-AOC-10G-50M 10G SFP+ 50 m

BlueOptics Active Optical Cable (AOC) CBO SFP-AOC-10G-50M 10G SFP+ 50 m is a factory-terminated duplex optical link engineered for short-reach 10 Gigabit Ethernet connections. The cable integrates SFP+ connectors into a single assembly, eliminating the need for separate transceivers and providing a compact, low-latency solution for server-to-switch or switch-to-switch links. With a 50 metre reach and plug-and-play compatibility with standard SFP+ ports, this AOC simplifies deployment in data centres and enterprise racks where reliable, high-bandwidth interconnects are required.

Advantages

The integrated design reduces component count by combining cable and transceivers into one unit, lowering installation time and inventory complexity. As a factory-terminated duplex AOC, it ensures consistent optical performance and signal integrity across the full 50 m length. The low-latency optical media and SFP+ form factor provide compatibility with existing 10G network equipment while reducing power consumption compared with separate active transceiver setups. The single-cable assembly also simplifies cable management in dense rack environments.

Suitable for

• Short-reach 10 Gigabit Ethernet links between servers and top-of-rack or end-of-row switches
• Switch-to-switch interconnects within server rooms and data halls
• High-density environments where simplified cable management is required
• Environments that require plug-and-play SFP+ connectivity without separate transceivers

Key specifications

• Data rate: 10 Gbit/s (SFP+ compatible)
• Length: 50 metres
• Connector type: SFP+ on both ends (factory-terminated duplex AOC)
• Cable type: Active optical cable (single assembly, duplex)
• Application: Short-reach multimode/10G Ethernet interconnects
• Latency: Low optical latency suitable for high-throughput links

How to use

Install the cable by inserting each SFP+ connector into the corresponding 10G SFP+ port on network devices until the connector latches. Do not force connectors; ensure ports support SFP+ modules and are powered off or follow hot-plug guidance from the device vendor. Route the cable to avoid tight bends and mechanical stress; maintain the manufacturer’s minimum bend radius and secure the assembly to rack infrastructure as needed. Once connected, verify link status indicators on the devices and confirm 10 Gbit/s link negotiation in device management interfaces.

Recommendations

Use the AOC for short-range 10G connections inside data centres and communications rooms, keep the cable away from sharp edges and heat sources, and ensure SFP+ ports are compatible with active optical cables. For high-density deployments, label both ends for easier maintenance and avoid exceeding the specified bend radius to preserve optical performance.