Cable óptico activo CBO 10G 5 m (SFP-AOC-10G-5M) para puertos SFP+

Active Optical Cable CBO 10G 5m (SFP-AOC-10G-5M) is a factory-terminated SFP+ direct-attach fiber solution that delivers 10 Gbps connectivity over a 5-metre duplex optical link. The cable integrates SFP+ form-factor active optical transceivers at each end, eliminating the need for separate transceivers and patch cords. It is intended for short-range high-speed interconnects such as switch-to-switch, server-to-switch and storage connections in rack and data centre environments, providing a compact, low-latency alternative to copper DACs and discrete fiber assemblies.

Advantages

The AOC offers stable 10 Gbps throughput with reduced electromagnetic interference and lower power consumption compared with equivalent electrical copper assemblies. Its plug-and-play SFP+ connectors simplify installation and reduce inventory management because transceivers and cable are combined into a single unit. The 5-metre length supports flexible rack-to-rack cabling while maintaining signal integrity and low latency for latency-sensitive applications.

Suitable for

• Top-of-rack and end-of-row switch uplinks
• Server-to-switch connections in data centres
• Storage area network (SAN) links and backup systems
• Short-range rack-to-rack high-speed interconnects

Key specifications

• Interface: SFP+ form-factor active optical modules at both ends
• Data rate: 10 Gbps
• Length: 5 metres
• Medium: Duplex multimode optical fibre (integrated AOC assembly)
• Latency: Low-latency design suitable for time-sensitive traffic
• Power consumption: Lower than typical copper direct attach equivalents
• Compatibility: Designed for SFP+ ports supporting active optical cables

How to use

Install by inserting each SFP+ connector into the corresponding SFP+ port on your network devices until the latch locks. No separate transceivers or patch cords are required. After insertion, verify link status via device indicators or management interfaces; drivers or additional configuration are rarely necessary on equipment that supports standard SFP+ modules. Handle the cable by the connector housings when routing; avoid tight bends and excessive pulling to preserve optical performance.

Recommendations

For reliable operation, use this 5-metre AOC in environments inside racks or between adjacent racks where distances do not exceed the cable length. Ensure SFP+ port compatibility with active optical assemblies and consult device interoperability lists if available. Avoid routing near high-temperature sources and maintain the minimum bend radius specified by the manufacturer to prevent fibre degradation.