Cable óptico activo InfiniBand CBO QSFP-AOC-10M-RW-BO 10 m, QSFP a QSFP

Active optical InfiniBand cable CBO QSFP-AOC-10M-RW-BO 10 m is a factory-terminated QSFP-to-QSFP fiber cable designed for short-range, high-bandwidth links between switches, servers and storage systems equipped with QSFP ports. The cable provides optical transmission over a 10-meter distance, offering electrical isolation and reduced electromagnetic interference compared with copper alternatives. It is intended for data center interconnects and rack-to-rack or shelf-to-shelf connections where low latency and simplified installation are required.

Advantages

This active optical cable combines QSFP connector compatibility with optical transmission to deliver reduced signal loss over the 10 m span and immunity to ground loop issues. Installation is simplified since no separate transceivers or patch cords are required: the single-cable solution minimizes connector pairs and cable management complexity. The optical medium reduces heat and power concerns associated with long copper runs and supports the low-latency requirements of InfiniBand networks.

Suitable for

• Short-range high-bandwidth links in data centers (switch-to-switch)
• Server-to-switch and server-to-storage connections within rack or nearby racks
• Low-latency InfiniBand fabrics and HPC clusters
• Environments requiring electrical isolation and reduced EMI

Key specifications

• Cable type: Active optical cable (AOC)
• Connection: QSFP (QSFP-to-QSFP)
• Length: 10 meters
• Applicable protocol family: InfiniBand / QSFP form-factor systems
• Transmission medium: Optical fiber with integrated active electronics
• Performance focus: Low latency, high bandwidth, short-reach interconnects
• Physical attributes: Factory-terminated, single integrated assembly for plug-and-play use

How to use

Install the cable by plugging each QSFP connector into the corresponding QSFP port on your network devices, ensuring correct alignment and secure seating. No separate SFP/QSFP transceivers or patch panels are required. Follow device vendor guidance for link configuration and any required port enabling or firmware compatibility checks. For reliable operation, avoid tight bends and excessive tension on the cable; maintain recommended bend radius and fasten cable runs using appropriate cable management to prevent strain on connectors.

Recommendations

Verify that both endpoints support QSFP optical AOC modules and the intended InfiniBand link speeds before deployment. Keep the cable away from sources of mechanical stress and maintain recommended bend radius. For installation in dense racks, plan routing to minimize looped lengths and to allow airflow around active equipment.