Cable óptico activo SFP+ CBO SFP-AOC-10G-20M 10 Gbps 20 m

The BlueOptics SFP+ Active Optical Cable CBO SFP-AOC-10G-20M delivers a direct 10 Gbps SFP+ connection over a 20-metre optical link. This factory-terminated AOC integrates optical transceivers and cable in a single assembly, enabling plug-and-play connectivity between servers, switches and storage devices without separate SFP+ modules. The cable is designed for short-reach high-speed interconnects in data centres and network aggregation points where low latency and immunity to electromagnetic interference are required.

Advantages

The active optical construction provides stable 10 Gbps throughput with reduced signal loss over 20 metres compared with copper alternatives. Integrated optics eliminate the need for separate transceivers, simplifying inventory and installation. The fibre-based link offers immunity to electromagnetic interference and improved thermal performance in dense rack environments. Low latency and consistent signal quality make the cable suitable for latency-sensitive applications and high-throughput links.

Suitable for

• Short-reach server-to-switch and switch-to-switch connections in data centres
• High-speed aggregation links and top-of-rack interconnects
• Storage area network (SAN) links and storage-to-switch connections
• Replacement of short-range copper cables where EMI immunity is required

Key specifications

• Interface: SFP+ connectors at both ends for 10 Gbps links
• Data rate: 10 Gbps full-duplex
• Length: 20 metres
• Cable type: Active optical cable with integrated transceivers
• Transmission medium: Multimode optical fibre suitable for short-reach links
• Latency: Low propagation delay optimized for high-throughput connections
• EMI immunity: Optical transmission provides resistance to electromagnetic interference

How to use

Install the AOC by inserting each SFP+ connector into the corresponding SFP+ port on networking equipment until it latches. Ensure both ends are compatible with 10 Gbps SFP+ ports and that equipment supports active optical cable operation. No additional transceivers or fibre patch cords are required. Check link status indicators on connected devices to confirm successful negotiation at 10 Gbps. Route the cable to avoid sharp bends and mechanical stress; follow equipment vendor guidelines for SFP+ connector handling to avoid damage to the optical interface.

Recommendations

For reliable operation, use the cable within the specified 20 metre range, avoid tight bends and excessive pulling force, and keep connector endfaces clean. When deploying in dense racks, plan cable routing to maintain airflow and prevent strain on SFP+ ports. Verify compatibility with switch and server models if vendor-specific transceiver restrictions apply.