Cable Twinax SFP+ CBO 2032247-2-BL 2 m conector macho/conector macho 10 Gbit/s

BlueOptics SFP+ Twinax Cable CBO 2032247-2-BL is a 2 m direct-attach copper cable with SFP+ male connectors on both ends, designed for 10 Gbit/s short-reach links. The cable provides a physical-layer solution for high-speed connections between switches, servers and network interface cards that accept SFP+ direct-attach cables. It is intended for data center and rack-to-rack interconnects where low latency and energy efficiency are required.

Advantages

The CBO 2032247-2-BL offers a fixed-length, low-latency copper connection that eliminates the need for separate transceivers and fiber patching for short distances. Its SFP+ male-to-male design ensures a compact connection with reduced power consumption compared with optical modules. The 2 m length balances reach and signal integrity for typical rack-to-rack and intra-rack scenarios, providing deterministic performance for 10 Gbit/s links.

Suitable for

• Short-reach connections between network switches in the same rack or adjacent racks
• Direct connections between servers and switches or NICs supporting SFP+
• Top-of-rack and aggregation layer links in data centers
• Environments where low latency and reduced power draw are priorities

Key specifications

• Connector type: SFP+ male on both ends
• Cable type: Direct-attach copper (twinax)
• Data rate: 10 Gbit/s
• Length: 2 meters
• Application: Short-reach, rack-to-rack and intra-rack interconnects
• Latency: Low, suitable for high-performance networking
• Power: Lower power consumption than equivalent optical transceivers

How to use

Insert each SFP+ connector into the corresponding SFP+ port on your switches, servers or NICs until the latch engages. Ensure both devices support SFP+ direct-attach copper cables and are configured for a 10 Gbit/s link. Verify link status in your devices' management interface and perform any required network configuration such as VLANs or MTU adjustments. For secure operation, avoid excessive bending near the connector ends and route the cable to prevent strain on ports.

Recommendations

Use this 2 m SFP+ twinax cable for short, fixed-length links where deterministic 10 Gbit/s performance, low latency and reduced power consumption are important. Avoid outdoor use and excessive physical stress; keep the cable within recommended bend radii and in temperature-controlled data center or server room environments.