CBO AOC Meraki SFP-AOC-10G-2M 10G cable óptico activo, 2 m, SFP+

The CBO AOC Meraki SFP-AOC-10G-2M 10G Active Optical Cable is a 2-metre SFP+ form-factor cable designed for short-range, high-speed interconnects. This active optical cable delivers 10 Gbps data transfer between switches, servers and network appliances while reducing the need for copper twinax cabling. It is a plug-and-play SFP+ solution made for SFP+ ports, offering a compact, low-latency link with lower power consumption and simplified rack cabling.

Advantages

The active optical design provides consistent 10 Gbps throughput across a 2 m optical link while minimizing electromagnetic interference and heat generation compared with copper cabling. The SFP+ form factor makes the cable compatible with standard SFP+ ports and keeps rack installations tidy by replacing bulkier copper DACs. Reduced power draw and lower signal attenuation improve overall link reliability for dense rack environments.

Suitable for

• High-density switch-to-switch connections in data centers
• Server-to-switch links requiring 10 Gbps bandwidth
• Interconnects between network appliances and top-of-rack switches
• Short-reach fibre connections inside racks and between adjacent racks

Key specifications

• Form factor: SFP+ active optical cable (AOC)
• Data rate: 10 Gbps
• Length: 2 metres
• Connector type: SFP+ plug on both ends
• Transmission medium: optical fiber with active transceivers integrated in the cable
• Typical use: short-range, high-speed interconnects in rack environments

How to use

Insert each SFP+ connector into the corresponding SFP+ port on the devices you want to interconnect, ensuring the latch engages. The link is plug-and-play and should be recognised by networking equipment that supports SFP+ AOC modules. Verify link status and speed in device management interfaces and monitor for any error counters during initial operation. For removal, press the connector latch and withdraw the module gently to avoid stressing ports or cable ends.

Recommendations

Install and route the cable within racks to avoid sharp bends and maintain the manufacturer’s minimum bend radius. Use AOC modules for short-reach connections where reduced weight, lower power and immunity to electromagnetic interference are priorities. Confirm device compatibility with SFP+ passive/active optical modules in firmware or hardware documentation before deployment.