CBO cable AOC para Ubiquiti Networks SFP-AOC-10G-50M — 10 Gbit/s, 50 m cable óptico activo

CBO AOC cable for Ubiquiti Networks SFP-AOC-10G-50M is an active optical cable that delivers 10 Gbps data throughput over a 50 meter link. Designed to connect devices with SFP+ ports, the cable integrates active optical transceivers into a single assembly to provide a plug-and-play connection between switches, servers and other network equipment. Its optical design eliminates susceptibility to electromagnetic interference and supports low-latency transmission for demanding network environments such as data centers and enterprise racks.

Advantages

The active optical construction enables high-speed 10 Gbps links without separate external transceivers and reduces rack space requirements. A 50 m reach covers cross-connects and typical intra-data-center spans while maintaining consistent signal integrity. Immunity to electromagnetic interference and reduced crosstalk improve reliability in dense cabling environments. The cable’s integrated design simplifies installation and replacement, eliminating fiber patching and minimizing configuration steps.

Suitable for

• 10 Gbps connections between switches in data centers and server rooms
• Direct links from servers to top-of-rack or spine switches
• High-density rack deployments where space and cable management are important
• Environments requiring immunity to electromagnetic interference

Key specifications

• Data rate: 10 Gbps
• Cable type: active optical cable (AOC)
• Nominal length: 50 m
• Connector interface: SFP+ form-factor compatible
• Latency: low-latency optical transmission
• Immunity: resistant to electromagnetic interference
• Installation: plug-and-play, integrated transceivers

How to use

Insert each SFP+ connector into the SFP+ port of the respective network devices until the module latches. Ensure both devices are powered and configured to support 10 Gbps links; link negotiation typically completes automatically. Route the cable to avoid sharp bends and secure it for proper strain relief. For diagnostics, verify link status LEDs on connected devices and check interface statistics in network management software.

Recommendations

For reliable operation, avoid bending the cable beyond the manufacturer’s minimum bend radius and keep it away from sources of mechanical stress. Use this cable for short- to medium-span intra-rack and inter-rack connections where a 50 m optical reach is appropriate. Confirm SFP+ port compatibility in device firmware or vendor documentation before deployment.