BlueOptics UACC-AOC-SFP10-5M-BO cable de fibra óptica InfiniBand SFP+ 5m conector/conector

The BlueOptics UACC-AOC-SFP10-5M-BO InfiniBand fibre optic cable SFP+ 5m Male/Male is a 5‑meter active optical cable (AOC) with SFP+ connectors at both ends, designed for high‑speed short‑reach links in data center and networking environments. It implements a multi‑mode fibre optical connection with integrated transmitter and receiver electronics in each SFP+ module and supports 10 Gbit/s data rates for Ethernet and other high‑speed protocols where SFP+ 10GBASE‑SR compatibility is required.

Advantages

This AOC provides an assembled, plug‑and‑play SFP+ to SFP+ connection that removes the need for separate patch cords and transceivers, reducing insertion loss and simplifying installation. The integrated digital diagnostics/monitoring functionality enables real‑time readouts of operating parameters where supported by host hardware. Built to MSA‑compliant SFP+ form factor and focusing on component quality, the cable is intended for extended operational lifetime and stable high‑speed transmission in supported devices.

Suitable for (tasks / use cases)

Key specifications

How to use

Insert each SFP+ module into the corresponding SFP+ port on your network devices until the module latches. Verify that both endpoints and the intermediate hardware support SFP+ 10GBASE‑SR or the applicable 10G SFP+ protocol. If your equipment supports digital diagnostics, enable or query DDM/DOM through the device management interface to monitor operating parameters such as transmit/receive power and temperature. No additional patching or fibre polishing is required because the cable is factory‑terminated.

Recommendations

Confirm compatibility with your switch, router or storage platform before deployment and ensure that the host firmware or software permits use of third‑party AOCs if required. Route the cable to avoid sharp bends and mechanical stress, and keep connector interfaces free of dust when inserting. For diagnostics and troubleshooting, use the host management tools to read DDM/DOM values where supported.