CBO transceptor de fibra óptica SFP-10G-BX-U 10G 1310nm SFP+ monomodo

The CBO SFP-10G-BX-U Fiber Optic Transceiver 10G 1310nm SFP+ Single-Mode is a compact SFP+ module engineered for 10 Gbps single-mode optical links at a 1310 nm wavelength. It is intended for use in SFP+ ports to establish point-to-point connections and uplinks where compact, hot-swappable hardware is required. The module supports single-mode fiber and is suitable for installations in data centers, carrier aggregation sites and enterprise switching environments that require reliable 10G throughput.

Advantages

The transceiver provides a standardized SFP+ form factor that enables hot-swappable installation and minimizes downtime during replacement or upgrade. With support for 10 Gbps transmission at 1310 nm on single-mode fiber, it offers stable, long-reach optical connectivity appropriate for uplinks and point-to-point links. Its compact design conserves port density on switches and routers while maintaining industry-standard electrical and optical interfaces for interoperability with compatible network equipment.

Suitable for

• Data center uplinks between switches and aggregation devices
• Carrier and metro transport point-to-point connections
• Enterprise core and distribution switch connections
• High-speed links in server racks and SAN environments

Key specifications

• Nominal data rate: 10 Gbps
• Optical wavelength: 1310 nm
• Fiber type: Single-mode fiber (SMF)
• Form factor: SFP+ (hot-swappable)
• Typical applications: Uplinks, point-to-point links, carrier and enterprise networks

How to use

Install the transceiver into an available SFP+ port on a switch, router or host adapter while the device is powered on or off according to the equipment vendor's guidance. Connect single-mode fiber patch cables with appropriate LC connectors, ensuring correct polarity and clean end faces. Monitor link status via the network device management interface and verify a 10 Gbps link. Replace or reseat the module if link errors are observed, following ESD precautions during handling.

Recommendations

Use certified single-mode fiber with matching LC connectors and observe the transceiver's supported wavelength and distance characteristics when planning links. Clean fiber connectors before mating and consult the network equipment compatibility list to ensure interoperability. Follow ESD handling practices and manufacturer guidance for hot-plug insertion and removal to avoid damage.