Módulo transceptor de fibra óptica BlueOptics VX_00009-BO 10000 Mbit/s SFP+ 1310 nm

The BlueOptics VX_00009-BO is a fiber optic transceiver module designed for high-speed networking applications. It uses the SFP+ interface and supports a maximum data transfer rate of 10000 Mbit/s. The module operates at a wavelength of 1310 nm for single-mode fiber links and comes in a silver housing with a lightweight form factor of approximately 20 g. It is RoHS-compliant and intended for integration into compatible switches, routers and other network devices that accept SFP+ modules.

Advantages

The transceiver provides 10G data throughput over single-mode fiber using a 1310 nm wavelength, offering low-latency optical transmission suitable for long-reach links. Its SFP+ form factor ensures broad compatibility with devices that support MSA-compliant modules. With a compact, lightweight silver enclosure and RoHS compliance, the module combines standard physical compatibility with environmental safety. The design focuses on stable optical performance for Ethernet and other high-speed protocols up to 10 Gbit/s.

Suitable for

Key specifications

How to use

Insert the BlueOptics VX_00009-BO into an available SFP+ slot on a compatible network device while the device is powered down or following the vendor-recommended hot‑swap procedure. Connect single-mode LC duplex fiber patch cords to the module’s optical ports, ensuring correct transmit/receive orientation. Configure the host device for the appropriate link speed and protocol (for example, 10GBase-LR or equivalent), verify link status on the device management interface, and, if available, enable digital diagnostics monitoring to read optical parameters. Follow the network equipment vendor’s compatibility and firmware recommendations for third‑party transceivers.

Recommendations

Use quality single-mode LC duplex patch cords and maintain proper fiber cleanliness to ensure optimal performance. Confirm that your network hardware supports SFP+ 10G modules and, if diagnostics are required, ensure the host supports DDM/DOM functions to monitor voltage, bias current, transmit/output power, receive/input power and temperature.