Módulo transceptor de red CBO BO35J13602D SFP+ 10.000 Mbit/s 1310 nm

CBO BO35J13602D is a SFP+ network transceiver module designed for 10,000 Mbit/s optical links at a wavelength of 1310 nm. The module supports single-mode fiber connections and is intended for high‑speed links between switches, routers and servers. It fits standard SFP+ ports and provides hot‑swappable, plug‑and‑play operation for straightforward integration into existing network equipment.

Advantages

The module delivers a stable 10 Gbps data rate over optical fiber with low power consumption and compact SFP+ form factor. Its 1310 nm wavelength is suitable for medium- to long-reach single-mode transmissions, providing consistent signal integrity and reduced interference compared with copper links. Hot‑swappable design enables maintenance or upgrades without powering down systems, and compatibility with standard SFP+ interfaces ensures broad interoperability across network hardware.

Suitable for

• 10 Gbps uplinks between data center switches and aggregation devices
• Server-to-switch optical connections in enterprise networks
• Fiber links between routers and metropolitan network endpoints
• Redundant optical paths and hardware upgrades without downtime

Key specifications

• Form factor: SFP+
• Nominal data rate: 10,000 Mbit/s (10 Gbps)
• Operating wavelength: 1310 nm
• Medium: single-mode fiber
• Interface: LC duplex optical connector
• Installation: hot‑swappable, plug-and-play
• Typical application: short to medium/long-reach optical links

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your switch, router or server until it latches. Connect LC-terminated single-mode fiber cables to the module, observing transmit/receive orientation. After physical installation the device should be recognised by the host equipment and negotiate a 10 Gbps link if supported. For removal, release the latch and gently pull the module out; perform installs and replacements while following equipment safety and electrostatic discharge precautions.

Recommendations

Verify compatibility with your network hardware and firmware, ensure fiber cable quality and proper connector cleanliness, and confirm link parameters (distance, attenuation, and transceiver power budget) for reliable 10 Gbps operation over single-mode fiber.