Módulo transceptor de red SFP+ CBO AA1403011-E6-BO 10 Gbit/s 1310 nm

The CBO BlueOptics SFP+ network transceiver module AA1403011-E6-BO provides a 10 Gbit/s optical link at a 1310 nm wavelength for single-mode fiber. Designed for insertion into SFP+ ports of switches, routers and servers, this transceiver supports high-speed Ethernet connections over medium to long reach fiber segments. The module enables reliable optical connectivity in environments such as data center uplinks, campus backbones and telecommunications links where stable 10GbE performance and compatibility with standard SFP+ interfaces are required.

Advantages

This SFP+ transceiver offers a standardized form factor and interoperable electrical and optical specifications that simplify integration into network equipment. It supports a 10 Gbit/s data rate and uses a 1310 nm wavelength optimized for single-mode fiber, providing a balance between reach and signal quality. The compact SFP+ design reduces space usage in high-density chassis and allows hot-plug replacement for minimal service disruption.

Suitable for (tasks / use cases)

• 10 Gigabit Ethernet uplinks between switches and core distribution
• Server-to-switch connections in data center racks
• Campus backbone links over single-mode fiber
• Telecom and carrier optical connections requiring 10GbE

Key specifications

• Form factor: SFP+
• Data rate: 10 Gbit/s
• Wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Connector type: LC duplex
• Hot-pluggable design

How to use

Insert the transceiver into an SFP+ slot in a powered network device following the vendor's insertion procedure. Connect the single-mode fiber cable with LC duplex connectors, ensuring proper polarity. Verify link status in the network device management interface and configure the interface for 10GbE operation where required. For safe handling, avoid touching the optical interfaces and use protective caps when the module is not connected.

Recommendations

Use clean, certified single-mode fiber cables and verify connector cleanliness before installation. Match the transceiver's wavelength and fiber type with the remote device to ensure link compatibility. Observe manufacturer thermal and mechanical limits and perform link tests after installation to confirm signal integrity.