Módulo transceptor SFP+ CBO 45W2411 10 Gbit/s 850 nm

SFP+ transceiver CBO 45W2411 10 Gbit/s 850 nm is a compact optical module that delivers 10 Gbit/s connectivity over multimode fiber at an 850 nm wavelength. Designed for short-range links, the module fits into standard SFP+ ports and supports hot-plug installation for easy replacement or extension of optical connections in switches, routers and servers. Its form factor and interface make it suitable for data center and enterprise environments where high-speed, low-latency links are required for aggregation and access layers.

Advantages

The module provides a standardized SFP+ form factor for compatibility with a broad range of networking equipment. With 10 Gbit/s throughput and operation at 850 nm, it is optimized for short-reach multimode fiber connections, offering predictable performance for intra-rack and short inter-rack links. Hot-pluggable design simplifies maintenance and upgrades without powering down systems, and the compact size maximizes port density in high-density environments.

Suitable for

• Short-range multimode fiber links in data centers
• Server-to-switch and switch-to-switch connections within racks
• Enterprise campus backbone segments requiring 10 Gbit/s
• Replacement or expansion of existing optical ports supporting SFP+

Key specifications

• Data rate: 10 Gbit/s
• Optical wavelength: 850 nm
• Supported fiber type: Multimode fiber (MMF)
• Form factor: SFP+
• Interface: Hot-pluggable electrical/optical SFP+ interface
• Typical application range: Short-reach (intra-rack and short inter-rack links)

How to use

Install the transceiver into an empty SFP+ socket on a switch, router or server by aligning the module with the port and inserting it until it latches. Connect multimode fiber patch cords with compatible LC connectors to the module's optical ports. Verify link status via the host device LED indicators or management interface and confirm 10 Gbit/s operation. To remove, depress the latch and gently pull the module out while the host is operational, taking standard electrostatic discharge and handling precautions.

Recommendations

Use appropriate multimode fiber (OM3/OM4) and LC patch cords to achieve rated short-reach performance. Keep protective caps on the optical interfaces when the transceiver is not connected and avoid exposing fiber ends to dust or damage. Check vendor compatibility lists for the host device if strict interoperability validation is required.