Módulo transceptor SFP+ CBO MFM1T02A-SR-BO 850 nm

The SFP+ Transceiver Module CBO MFM1T02A-SR-BO 850 nm is a hot-pluggable optical module designed for short-range 10 Gigabit Ethernet connections over multimode fiber. It provides a compact SFP+ form factor for easy integration into compatible switches, servers and optical equipment. The module supports 10Gb/s data rates at an 850 nm wavelength, making it suitable for typical data-center and enterprise short-reach links that require reliable high-speed connectivity.

Advantages

This SFP+ transceiver offers hot-pluggable convenience and a standardized SFP+ form factor for straightforward installation and replacement. Operating at 850 nm, it delivers reliable short-range 10Gb/s transmission over multimode fiber, with compatibility aimed at common network ports for server uplinks and switch interconnects. The compact design reduces space requirements in dense rack environments and supports typical diagnostic and control features defined for SFP+ modules.

Suitable for

Key specifications

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot on a switch, server NIC or optical device while the host port is powered according to the equipment manual. Secure the module and connect LC duplex multimode fiber patch cords to establish the optical link. Confirm link status and data rate through the host device interface or management software. To remove, power down the appropriate port if required by the host equipment, release the module latch and pull the transceiver straight out to avoid damaging the fiber connector.

Recommendations

Use short-length OM3/OM4 multimode fiber for best performance at 10Gb/s and avoid tight bends or excessive pulling on fiber cables. Ensure compatible SFP+ slots and firmware support on host devices for smooth interoperability. Store unused transceivers with dust caps on the optical interfaces to prevent contamination.