BlueOptics Q28-AOC-25M-NK-BO Cable de fibra óptica InfiniBand 25 m OM3

The BlueOptics Q28-AOC-25M-NK-BO InfiniBand fibre optic cable 25m OM3 is an active optical cable (AOC) with QSFP28 connectors on both ends, designed for 100G high-speed transmissions over short distances. It uses OM3 multimode fibre with a 50 µm core diameter and LSZH (low smoke zero halogen) sheath for reduced smoke and no halogen emissions. The built-in optical-electrical conversion in each connector enables hot-pluggable QSFP28-to-QSFP28 connections for servers, switches and network devices within racks or between adjacent racks.

Advantages

Compared to passive twinax solutions, this BlueOptics AOC offers lower weight, greater flexibility and a smaller bend radius while maintaining high 100GBASE-SR4 performance. The QSFP28 transceiver connectors comply with MSA, SFF and IEEE specifications and include integrated I/O and O/E converters for reliable signal conversion. The cable is factory-tested and assembled from quality components to meet CE and RoHS guidelines and common industrial standards.

Suitable for

• Short-reach 100G connections between network switches and servers in data centres
• High-performance computing clusters requiring low-latency InfiniBand links
• Inter-rack connectivity within the same equipment room or adjacent racks
• Environments where reduced cable weight and improved bend radius are needed

Key specifications

• Cable type: Active Optical Cable (AOC)
• Connector type: QSFP28 to QSFP28 (hot-pluggable)
• Length: 25 m
• Fibre type: OM3 multimode
• Core diameter: 50 µm
• Data rate support: 100G (100GBASE-SR4)
• Sheath: LSZH (low smoke, zero halogen)
• Bend radius: smaller than typical twinax; designed for improved flexibility

How to use

Insert each QSFP28 connector into the corresponding QSFP28 port on the network devices until the connector latches. The built-in transceivers perform the electrical-to-optical and optical-to-electrical conversion automatically; no additional modules are required. Ensure both ends are clean and free of dust before connecting and route the cable to avoid tight bends that could stress the fibre despite its improved bend radius. The AOC supports hot-plug operation, so it can be connected or removed while devices are powered on if the system supports hot-plugging.

Recommendations

Inspect connector ferrules with appropriate cleaning tools or lint-free wipes before each installation. Avoid sharp bends and excessive pulling force; secure the cable with gentle cable management to maintain performance and longevity.