BlueOptics SFP-10G-BX-U-20-NG-BO Módulo transceptor de red de fibra óptica 10000 Mbit/s SFP+

The BlueOptics SFP-10G-BX-U-20-NG-BO is an SFP+ fiber optic transceiver module designed for 10 Gigabit network links. Built in a compact metal housing and weighing just 20 g, the module supports a maximum data transfer rate of 10,000 Mbit/s and is suitable for single-mode long-range optical connections. It complies with RoHS and FCC requirements and implements bidirectional (BiDi) wavelength technology to transmit and receive on separate wavelengths over a single fiber, enabling efficient use of existing fiber infrastructure.

Advantages

The transceiver offers 10 GbE performance in an industry-standard SFP+ form factor, enabling interoperability with compatible switches, routers and storage systems. BiDi operation doubles effective bandwidth on a single fiber line by using two wavelengths, reducing cabling needs. The metal housing provides mechanical stability and heat dissipation while compliance with RoHS and FCC standards ensures regulatory compatibility. Low weight and a pluggable SFP+ interface make installation, replacement and upgrades straightforward.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures for your host device per manufacturer instructions, then insert the SFP+ module into an available SFP+ port until it seats and the retention latch engages. Connect LC simplex single-mode fiber patch cords with the correct orientation for the module's transmit and receive wavelengths. After insertion, verify link lights and check device logs or management interfaces for link negotiation and diagnostics. Use the DOM/DDM interface to monitor optical power, temperature and supply voltage during commissioning and operation.

Recommendations

Confirm compatibility with the host device vendor regarding supported SFP+ transceivers and enable any necessary port settings for 10 Gb operation. When deploying BiDi modules, match the complementary wavelength module at the far end (e.g., 1270 nm ↔ 1330 nm) and label fiber runs to avoid confusion. Observe ESD precautions during handling, maintain clean LC connectors, and perform optical power and BER tests during installation to validate link performance.