BlueOptics SFP28-25G-ERL-30-SS-BO Módulo transceptor SFP28 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-SS-BO is a fiber optic transceiver module designed for high-speed point-to-point links in data center and enterprise environments. With an SFP28 interface and support for up to 25,000 Mbit/s, the module provides a compact, hot-pluggable solution for modern switches, routers and optical equipment. Its form factor and electrical compatibility make it suitable for upgrading 25G-capable ports while maintaining backward compatibility with common SFP-based platforms.

Advantages

The SFP28-25G-ERL-30-SS-BO combines a small footprint and industry-standard SFP28 connectivity to deliver 25 Gbit/s performance where space and power savings are important. Its hot-pluggable design simplifies maintenance and replacement without interrupting adjacent ports. The module is intended to support reliable optical links at 25,000 Mbit/s while fitting existing SFP28 cages and electrical interfaces.

Suitable for

• 25G uplinks between switches and aggregation devices
• High-performance server-to-switch connections in data centers
• Enterprise backbone links requiring optical reach and low latency
• Upgrading SFP-capable network equipment to 25G speeds

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25,000 Mbit/s
• Form factor: SFP28 transceiver module, hot-pluggable
• Application: single-channel 25G optical data transmission for networking equipment

How to use

Insert the transceiver into a compatible SFP28 port on a powered-down or hot-pluggable device according to the host vendor’s instructions. Ensure the module is fully seated and secured in the cage, then connect the appropriate single-mode or multimode fiber cable (as required by the optical variant and link design). Verify link status via the host device management interface and, if necessary, configure port speed and duplex settings to use 25G operation. Follow equipment vendor guidelines for handling electrostatic-sensitive components and observe recommended bending radii for fiber cables.

Recommendations

Use the BlueOptics SFP28-25G-ERL-30-SS-BO in compatible SFP28 ports on switches, routers and transceivers designated for 25G links. Check host device compatibility lists and firmware requirements before deployment. For optimal performance, use factory-tested fiber patch cords, maintain proper fiber cleanliness, and monitor link health through standard network management tools.