Transceptor CBO Fujitsu S26361-F3206-E10 Fibra óptica XFP 10G

The Transceiver CBO Fujitsu S26361-F3206-E10 Fiber Optic XFP 10G is a compact, hot-pluggable module for 10 Gigabit Ethernet links. Designed for use in compatible optical networking equipment, the XFP form factor supports high-speed data transmission over single-mode fiber for extended link distances. The module is intended for upgrading or restoring fiber ports in switches, routers and transport devices that require 10G fiber connectivity and straightforward installation.

Advantages

This XFP transceiver offers a small form factor and hot-swappable design, allowing replacements or upgrades without powering down equipment. It supports 10G data rates and is suitable for long-distance single-mode fiber connections, enabling network uplinks and high-throughput links. The module is compatible with standard XFP interfaces and simplifies deployment in environments where compact, reliable 10G fiber optics are required.

Suitable for

Key specifications

How to use

Install the XFP transceiver into a compatible XFP port on your switch, router or transport device while the equipment is powered on if hot-swap capability is supported. Ensure the module is fully seated and latched, then connect the appropriate single-mode fiber patch cable with matching connectors. Configure the host device for 10 Gigabit Ethernet operation and verify link status through the device management interface or LEDs. For replacements, remove the failed module carefully and insert the new transceiver following the same steps.

Recommendations

Verify equipment compatibility and supported optical wavelengths before installation. Use quality single-mode fiber and clean connectors to maintain signal integrity. Observe electrostatic discharge precautions when handling the module and store unused transceivers in protective packaging.