Transceptor CBO NTTP01AF fibra óptica 1000Base-SX 850nm

The Transceiver CBO NTTP01AF Fiber Optic 1000Base-SX 850nm is a hot-pluggable SFP module designed for Gigabit Ethernet links over multimode fiber. It operates at an 850 nm wavelength and supports the 1000Base-SX standard, providing short-reach optical connectivity for data center, campus and enterprise networks. The module is compatible with networking equipment that accepts SFP-form factor transceivers and is intended for straightforward installation into SFP slots on switches and routers.

Advantages

This SFP transceiver delivers reliable multimode optical transmission at gigabit speeds while remaining compact and energy-efficient. It offers plug-and-play interoperability for systems that support standard 1000Base-SX optics, reducing installation effort and downtime. The module’s design is suitable for short-reach links, minimizing cost while maintaining stable performance for typical intra-building and rack-to-rack connections.

Suitable for

Key specifications

How to use

Install the transceiver by inserting it into an available SFP slot on a compatible switch or router until it clicks into place. Connect LC duplex multimode fiber patch cables to the module, ensuring correct transmit/receive orientation. Verify link status through the host device’s interface or LED indicators and configure network settings as required. For removal, power down the port if recommended by the equipment vendor or follow hot-swap procedures supported by the host device, then depress the release latch and gently pull the transceiver from the slot.

Recommendations

Use high-quality multimode fiber and LC patch cables matched to the intended distance (OM1/OM2/OM3/OM4 as appropriate) to achieve expected link performance. Observe ESD precautions when handling the module and keep protective dust caps on the optical connectors when not in use. Confirm host compatibility with 1000Base-SX SFP modules before deployment and consult the switch/router documentation for any specific firmware or configuration requirements.