Transceptor CBO SFP-10G-BX-D fibra óptica 10G monomodo SFP+

The CBO Transceiver SFP-10G-BX-D Fiber Optic 10G Single‑Mode SFP+ is a compact optical module designed for 10 Gigabit Ethernet links in single‑mode networks. Compatible with SFP+ ports on switches and routers, this BlueOptics transceiver supports duplex communication using distinct transmit and receive wavelengths, enabling long‑reach fiber connections for uplinks and interconnects in data centers, carrier networks and enterprise backbones.

Advantages

This SFP+ module provides reliable 10 Gbps throughput with low power consumption and a form factor that fits standard SFP+ cages. Its single‑mode design and wavelength‑separated TX/RX channels allow point‑to‑point links over extended distances, reducing the need for intermediate hardware. The module is engineered for hot‑swappable operation, simplifying maintenance and upgrades without interrupting network operation.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Data center interconnects and aggregation links
• Carrier and metropolitan area network (MAN) long‑reach connections
• Enterprise backbone and campus fiber links

Key specifications

• Interface: SFP+ form factor for 10 Gigabit Ethernet
• Fiber type: single‑mode fiber (SMF)
• Transmission: duplex using separate TX and RX wavelengths
• Data rate: 10 Gbps
• Hot‑swappable module design
• Low power consumption suitable for dense port deployments

How to use

Insert the transceiver into an available SFP+ port on a compatible switch or router until it clicks to secure. Connect single‑mode fiber cables with appropriate LC connectors to the TX and RX ports following the device labeling to ensure correct directionality. After physical installation, verify link negotiation and speed in the network device management interface; no additional software is typically required. For hot‑swap replacement, remove the module while the system is powered and insert the new module, then confirm the link state.

Recommendations

Use single‑mode fiber with low‑loss connectors and maintain proper fiber handling to avoid bends and contamination. Check compatibility with the network equipment vendor's SFP+ specifications and firmware guidance. For long‑distance links, verify budget and dispersion limits for the selected fiber route and consider using certified patch cords and cleaning tools to ensure optimal performance.