Transceptor CBO SFP-10G-LR módulo óptico monomodo 10Gbps 1310nm

SFP-10G-LR CBO is a 10Gbps SFP+ optical transceiver designed for single-mode fiber links at a wavelength of 1310 nm. The module supports long-reach 10 Gigabit Ethernet transmission over single-mode fiber, providing a compact hot-pluggable form factor that fits standard SFP+ ports on switches, routers and servers. It is intended for use in data center and enterprise network environments where reliable high-speed uplinks and connections between equipment are required.

Advantages

The transceiver delivers 10 Gbps data rate with single-mode fiber compatibility and a 1310 nm operating wavelength, offering long-reach connectivity and stable optical performance. Its SFP+ form factor enables hot-pluggable installation without disrupting system operation. The module is interoperable with common networking equipment that accepts standard SFP+ optics, and its compact design reduces rack space and simplifies upgrades from lower-speed interfaces.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and aggregation points
• Long-distance links in campus and data center interconnects over single-mode fiber
• High-speed connections to routers, servers and optical transport equipment
• Network upgrades where SFP+ slots are available for modular optics

Key specifications

• Data rate: 10 Gbps
• Fiber type: single-mode
• Operating wavelength: 1310 nm
• Form factor: SFP+ (hot-pluggable)
• Typical reach: long-reach single-mode links (manufacturer guidelines apply)
• Interfaces: duplex LC optical connector
• Power and thermal: compatible with SFP+ power envelopes and typical switch port cooling requirements

How to use

Insert the SFP+ transceiver into an available SFP+ port on the switch, router or server until it clicks into place, then connect single-mode duplex LC fiber patch cords to the module's optical ports, observing correct transmit/receive orientation. Ensure connected equipment is powered and configured to recognize SFP+ optics; check link status through device management interfaces. Replace or remove the module while the host device supports hot-pluggable optics, following proper electrostatic discharge (ESD) precautions.

Recommendations

Use high-quality single-mode fiber and certified LC patch cords, verify compatibility with the host device's optical power and DDM/monitoring requirements, and follow the equipment manufacturer's installation and maintenance guidelines to ensure reliable long-reach 10GbE links.