Transceptor XFP BlueOptics SU58BB-BO 10000 Mbit/s 1310 nm plata

The BlueOptics SU58BB-BO XFP transceiver is designed for high-speed optical links with a maximum data rate of 10000 Mbit/s. It operates at a wavelength of 1310 nm, uses an XFP interface and is housed in a durable silver metal casing. The module is lightweight (approx. 2 g) and requires a 3.3 V input voltage. It supports single-mode fibre connections with LC duplex termination and is intended for use in networking hardware that accepts XFP 10G modules.

Advantages

The transceiver provides 10G data throughput over single-mode fibre using a 1310 nm transmitter and receiver, enabling long-reach optical links when used with compatible hardware. Its metal housing offers mechanical robustness and thermal stability, while the low weight facilitates installation in dense equipment. The module follows common XFP form-factor conventions and is manufactured to MSA-compatible component standards to ensure interoperability with devices that support XFP 10G modules.

Suitable for

Key specifications

How to use

Install the XFP transceiver into a compatible XFP slot following the host device manufacturer’s hot-swap and electrostatic discharge precautions. Connect LC duplex single-mode fibre patch cords to the transmit and receive ports, ensuring correct polarity. Power is supplied through the host interface (3.3 V requirement is met by the host). Verify link status via the host device and, if supported, enable or query digital diagnostics (DDM/DOM) through the system management interface to monitor operating parameters.

Recommendations

Use single-mode LC duplex fibre patch cords and patch panels rated for 1310 nm to achieve intended reach and signal quality. Confirm that the host hardware supports XFP 10G modules and, where needed, DDM/DOM functions for remote monitoring. Observe ESD handling and manufacturer guidelines during installation to ensure reliable operation.