Transceptor de cobre SFP+ CBO E10GSFPT-BO 10GBASE‑T 10 Gbit/s, hasta 30 m

CBO E10GSFPT-BO is an SFP+ copper transceiver that implements 10GBASE‑T to deliver 10 Gbit/s Ethernet over standard twisted‑pair copper cabling. The module is intended for use in networking equipment with SFP+ ports and provides short‑reach 10 GbE links with a maximum reach of up to 30 m over Cat6/Cat6a cabling. It supports typical data center and enterprise scenarios such as server uplinks, top‑of‑rack switches and direct connections to storage systems where reuse of existing copper infrastructure is preferred.

Advantages

This SFP+ copper transceiver allows 10 Gbit/s connectivity without requiring fiber optics, enabling quick deployment over existing copper cabling. Its compact SFP+ form factor fits directly into SFP+ ports on switches, routers and servers, reducing the need for additional converters or media modules. The module supports low‑latency 10 GbE links suitable for high‑performance networking while simplifying cabling and lowering short‑reach installation cost.

Suitable for

Key specifications

How to use

Insert the transceiver into an available SFP+ port until it clicks into place, ensuring the host device is powered off or that hot‑swap is supported by the equipment. Connect the other end using compliant twisted‑pair copper cabling terminated with RJ45 connectors, observing the maximum recommended cable type and length to maintain performance. Configure the host interface as required by the switch, router or server operating system to enable the 10GBASE‑T link and verify link status and speed through device management tools.

Recommendations

For reliable 10 Gbit/s performance, use high‑quality Cat6a cabling for runs close to the 30 m limit and follow manufacturer guidelines for cable installation and grounding. Verify compatibility with the switch or server vendor and ensure firmware or driver updates are applied when needed to support SFP+ copper modules.