Transceptor 10G XFP LC LR HP Enterprise X130 (modelo JD108B-RFB)

HP Enterprise X130 10G XFP LC LR Transceiver (model JD108B-RFB) is a hot-pluggable optical module designed for 10 Gigabit Ethernet links. The XFP form factor with an LC duplex connector supports long-range (LR) transmission over single-mode fiber, enabling extended-distance connectivity for backbone and data-center uplinks. The module is compatible with networking equipment that accepts industry-standard XFP interfaces and is intended to provide reliable, high-speed optical links for switches, routers, and aggregation devices.

Advantages

The transceiver delivers 10 Gbps data rates and long-range optical reach in an XFP form factor, enabling flexible deployment in existing XFP-capable ports. Hot-pluggable design allows insertion and removal without powering down connected equipment. Using an LC connector ensures compatibility with common single-mode duplex fiber cabling. The module is engineered to meet typical industry interoperability and optical performance requirements for LR links.

Suitable for

• Data-center uplinks between core and aggregation switches
• Backbone links in campus and enterprise networks
• Inter-router fiber connections over extended distances
• Optical upgrades where XFP form-factor ports are available

Key specifications

• Brand: HP Enterprise
• Model / MPN: JD108B-RFB
• Product type: 10G XFP transceiver
• Connector: LC duplex
• Reach: Long Range (LR) over single-mode fiber
• Data rate: 10 Gigabit Ethernet
• Hot-pluggable: Yes
• EAN: 5706998322678

How to use

Ensure the host device supports XFP modules and is compatible with third-party or HP Enterprise XFP transceivers. Power on the network device and insert the JD108B-RFB module into an available XFP slot until it seats firmly. Connect LC duplex single-mode fiber cables to the module, observing correct transmit/receive orientation. Monitor the device interface indicators and management system to verify link negotiation at 10 Gbps and confirm optical signal parameters. To remove, power down the interface if required by your operational procedures or follow hot-swap guidelines, then gently pull the module from the slot.

Recommendations

Use single-mode LC duplex fiber for LR links and ensure connectors and patch panels are clean to avoid signal loss. Verify firmware and compatibility notes for your switch or router model before deployment. For long-distance links, plan for appropriate optical budget and, if needed, perform optical power and loss measurements during installation and commissioning.