Transceptor de fibra óptica CBO 407-BBEE SFP+ 10 Gbit/s LC 1310 nm

CBO 407-BBEE SFP+ 10 Gbit/s LC 1310 nm is a hot-pluggable fiber optic transceiver module designed for 10,000 Mbit/s data transmission over single-mode fiber. With an LC duplex connector and an operating wavelength of 1310 nm, this SFP+ form factor module supports short- to medium-distance uplink and backbone links in switches, routers and servers. The module is intended for network environments where reliable, low-latency 10 Gbit/s optical connections are required and facilitates upgrades to higher-speed infrastructures while maintaining compatibility with standard SFP+ ports.

Advantages

The module provides a compact SFP+ solution for 10 Gbit/s optical links, enabling easy installation and maintenance thanks to its hot-pluggable design. It supports common network equipment with LC duplex interfaces and offers stable performance for uplink and aggregation scenarios. Low power consumption and compliance with standard optical parameters contribute to predictable link behavior and interoperability in mixed-vendor networks.

Suitable for

• 10 Gbit/s uplinks between switches and routers
• Server-to-switch connections in data centers
• Backbone and aggregation links over single-mode fiber
• Network upgrades from 1 Gbit/s to 10 Gbit/s

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbit/s
• Connector type: LC duplex
• Operating wavelength: 1310 nm
• Fiber type: single-mode
• Typical application range: short to medium distances
• Power consumption: low (SFP+ class)

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on your switch, router or server until it seats firmly; secure any port latches as required by the host device. Connect an LC duplex single-mode fiber cable with correct polarity to the module. Configure link settings on the host device as necessary for 10 Gbit/s optical operation and verify link status via the equipment management interface. To remove the module, power down the port if required by your hardware policy, release the latch and pull the module straight out to avoid fiber strain.

Recommendations

Use clean single-mode fiber and inspect connector endfaces before insertion to ensure optimal signal quality. Match the module's wavelength and connector type to your existing fiber infrastructure. Observe ESD precautions when handling the transceiver and store it in protective packaging when not in use.