Transceptor de fibra óptica SFP+ CBO SFP-10G-BX-U 10G 1310nm

The BlueOptics SFP+ Fiber Optic Transceiver CBO SFP-10G-BX-U 10G 1310nm is a compact optical module that supports 10 Gigabit Ethernet transmission over single-fiber links. Engineered for use in compatible SFP+ slots, this transceiver provides a 1310 nm transmit wavelength and is intended for point-to-point connections where single-fiber, bidirectional communication reduces fiber cabling. Its small form factor enables straightforward installation and integration into data center switches, aggregation equipment and enterprise access devices.

Advantages

This transceiver offers 10 Gbit/s data rate capability with single-fiber operation, allowing cost-efficient use of existing fiber infrastructure. The compact SFP+ form factor ensures broad compatibility with SFP+ ports and easy hot-swap replacement. The optical design focuses on reliable long-distance links with stable wavelength characteristics, supporting network upgrades and maintenance with minimal disruption.

Suitable for

• 10 Gigabit Ethernet uplinks in data center and campus networks
• Single-fiber bidirectional links where duplex fiber is limited
• Network upgrades requiring SFP+ transceivers with 1310 nm transmit wavelength
• Interconnection between switches, routers and media converters in enterprise environments

Key specifications

• Data rate: 10 Gbit/s
• Transmit wavelength: 1310 nm
• Form factor: SFP+
• Single-fiber bidirectional operation (bi-directional/BCM)
• Protocol support: 10 Gigabit Ethernet
• Hot-swappable module design

How to use

Install the transceiver into a compatible SFP+ port on the network device until it clicks into place. Connect the single-fiber duplex by using the appropriate bidirectional single-fiber patch cables or adapters, ensuring transmit and receive fibers are matched according to link polarity. Configure the host device for 10 Gigabit Ethernet operation if required and verify link status through the device management interface. Replace or move the module as needed without powering down equipment, observing electrostatic discharge precautions during handling.

Recommendations

Use this SFP+ transceiver with certified single-mode fiber and appropriate connectors; verify compatibility with the target switch or router vendor documentation. For reliable long-distance links, confirm link budget and attenuation values and keep connectors clean to maintain low insertion loss.