Módulo transceptor SFP BlueOptics MT9101-BO 1250 Mbit/s fibra óptica

The BlueOptics MT9101-BO is an SFP fiber optic transceiver module designed for multimode optical links with a maximum data transfer rate of 1250 Mbit/s. Finished in silver and weighing approximately 20 g, this compact module uses an LC Duplex connection and follows MSA mechanical standards for hot-pluggable single‑slot deployment in switches, routers and other network equipment. The transceiver implements 850 nm transmit and receive functions for short-range multimode fiber applications and complies with CE, RoHS and FCC regulations.

Advantages

The module offers a standardized SFP form factor that enables straightforward replacement or upgrade of existing ports without modifying host hardware. Built to MSA compatibility, the MT9101-BO supports common network platforms and provides stable optical transmission with low electromagnetic susceptibility inherent to fiber links. Digital diagnostic monitoring is supported, allowing real-time readout of supply voltage, laser current, optical power and temperature where the host device also supports DDM/DOM. The small size and light weight simplify installation and equipment handling.

Suitable for

Key specifications

How to use

Insert the MT9101-BO into an empty SFP port on a powered host device according to the host manufacturer’s hot‑swap procedure. Connect LC Duplex multimode fiber patch cables (matching the transceiver’s wavelength and fiber type) to the module’s LC connector. Configure the host port as required by your network settings and verify link status and throughput. If available and needed, enable and read Digital Diagnostic Monitoring values through the host management interface to monitor optical power and environmental parameters.

Recommendations

Use OM3/OM4 multimode fiber for optimal short-range performance and ensure polarity-correct LC Duplex cabling. Confirm host device compatibility with SFP modules and DDM/DOM support before deployment. Handle the transceiver by its housing, keep protective caps on unused connectors to avoid contamination, and follow ESD precautions during installation.