Transceptor óptico CBO SFP-10G-ZR 10G monomodo SFP+

The CBO SFP-10G-ZR 10G Single-Mode SFP+ is an optical transceiver module engineered for long-reach 10 Gigabit Ethernet connections over single-mode fiber. Designed to plug into SFP+ ports, this compact module provides high-speed fiber links suitable for data center uplinks, metropolitan networks and point-to-point transmissions between switches, routers and optical equipment. The transceiver supports standard 10G encoding and is intended for straightforward integration into existing network hardware that accepts SFP+ optics.

Advantages

The module combines a small form factor with long-distance transmission capability, allowing network operators to extend links without changing switch hardware. It reduces cabling complexity by using single-mode fiber and supports 10 Gbps throughput for latency-sensitive applications. Compatibility with SFP+ slots makes installation simple and the unit’s passive design minimizes additional power and cooling requirements in dense rack environments.

Suitable for

• Data center uplinks and spine-leaf connections
• Long-distance point-to-point links in campus and metro networks
• Inter-switch and router-to-router fiber connections
• Telecom aggregation and optical transport equipment

Key specifications

• Form factor: SFP+ (10G)
• Fiber type: single-mode
• Data rate: 10 Gigabit Ethernet (10 Gbps)
• Typical reach: long-reach wavelength optimized for extended distances over single-mode fiber
• Interface: LC duplex
• Hot-pluggable SFP+ module compatible with standard SFP+ ports

How to use

Insert the SFP+ transceiver into an available SFP+ port on a switch, router or optical device until it clicks into place. Connect single-mode fiber cables with LC duplex connectors to the module ports, ensuring correct transmit/receive orientation. Configure the network device for 10Gbps operation and verify link status via the device management interface. For initial deployment, confirm that fiber type, link budget and wavelength compatibility match the receiving equipment.

Recommendations

Handle the transceiver by its housing, avoid touching the optical ferrule, and keep dust caps on ports when not connected. Verify device compatibility and supported temperature ranges in the host equipment documentation. Use clean single-mode fiber and appropriate patching practices to maintain signal quality.