Transceptor óptico SFP+ CBO 00Y2523-BO 10 Gbit/s 850 nm

CBO 00Y2523-BO is an SFP+ optical transceiver module that supports a 10 Gbit/s data rate over multimode fiber using an 850 nm wavelength. The module is designed for short-range links and provides a hot-pluggable form factor compatible with standard SFP+ ports on switches, routers and servers. It is intended for use in data center uplinks, storage area networks and other high-speed network interconnects where compact, field-replaceable modules simplify deployment and maintenance.

Advantages

The transceiver offers 10 Gbit/s throughput in a compact SFP+ package with an 850 nm VCSEL interface for reliable short-range multimode transmission. Its hot-pluggable design allows replacement or upgrades without powering down equipment. The module is engineered for low power consumption and predictable optical performance, enabling consistent link behavior in densely populated rack environments.

Suitable for

• Short-range 10 Gigabit Ethernet links over multimode fiber
• Data center uplink ports on switches and routers
• Server NICs and storage area network (SAN) interconnects
• High-density aggregation and spine-leaf fabrics

Key specifications

• Interface: SFP+ form factor, hot-pluggable
• Data rate: 10 Gbit/s
• Wavelength: 850 nm (multimode VCSEL)
• Optical reach: designed for short-range multimode fiber links
• Connector type: LC duplex
• Power consumption: low-power design suitable for dense installations
• Operating environment: typical data center temperature range

How to use

Insert the SFP+ transceiver into a compatible SFP+ slot until it latches securely, then connect duplex LC multimode fiber patch cables. Ensure both ends of the link use matching transceiver types and fiber types (multimode) to achieve the specified reach and performance. Monitor link LEDs on network equipment and verify 10 Gbit/s link establishment through device management interfaces. For removal, disengage the latch and pull the module straight out to avoid damage.

Recommendations

Use this 850 nm SFP+ module with multimode fiber (OM3/OM4 recommended for best performance) and LC duplex connectors. Store and handle the module and fiber connectors with dust caps in place to prevent contamination. Verify compatibility with the target switch or router vendor and consult device documentation for supported transceiver lists and firmware considerations.