Transceptor SFP+ CBO 10G-SFPP-ER-FY fibra óptica 10G

SFP+ Transceiver CBO 10G-SFPP-ER-FY Fiber Optic 10G is a 10 Gigabit optical module compatible with standard SFP+ ports. Designed for long-reach optical links, this transceiver provides high-speed connectivity for switches, routers and servers in data center, metro and enterprise networks. The module follows the SFP+ form factor for hot-pluggable installation and supports single-mode fiber links suitable for extended-distance connections, enabling straightforward replacement or upgrade of existing SFP+ ports.

Advantages

The transceiver offers 10 Gbps data rate in a compact SFP+ package, allowing high-density installation in network devices. Its single-mode fiber design supports long-distance transmission, reducing the need for intermediate repeaters or additional hardware on extended links. Hot-pluggable operation simplifies maintenance and hardware changes without powering down equipment. The module is compatible with a wide range of network switches, routers and servers that accept standard SFP+ optical modules.

Suitable for

• Long-reach data center uplinks and inter-rack connections
• Metro area optical links between buildings and campuses
• Enterprise network backbones and server connectivity
• Optical links requiring single-mode fiber and 10 Gbps bandwidth

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gigabit per second
• Fiber type: single-mode fiber (SMF)
• Optical wavelength: optimized for extended-reach transmission
• Typical application: long-reach optical links (ER class)

How to use

Insert the SFP+ transceiver into an available SFP+ port on your switch, router or server until it latches. Connect single-mode fiber cables with the appropriate connectors to the module’s optical interface, ensuring correct transmit/receive orientation. After physical installation, verify link status in the network device’s management interface and configure interface parameters (speed, duplex if required, and any vendor-specific settings). For hot-swap replacement, remove the old module and insert the new transceiver without shutting down the host device, following electrostatic discharge precautions.

Recommendations

Use single-mode fiber patch cords of adequate quality and maintain clean connector endfaces to ensure reliable link performance. Check device compatibility with SFP+ optical modules and confirm supported wavelength and reach class for intended links. Handle the transceiver carefully, avoid touching optical interfaces, and store unused modules in protective caps to prevent contamination.