Transceptor SFP+ CBO 90Y9412-BO 10 Gbps 1310 nm

CBO 90Y9412-BO is an SFP+ optical transceiver module that supports a 10 Gbps data rate and operates at a wavelength of 1310 nm. Intended for high-speed fiber connections, this compact hot-pluggable module fits standard SFP+ slots in switches, routers and servers. The transceiver is designed for short- to mid-range single-mode fiber links and enables straightforward integration during network upgrades and maintenance without requiring system shutdowns.

Advantages

The transceiver offers a reliable 10 Gbps throughput with a 1310 nm optical wavelength, ensuring stable transmission over suitable fiber distances. Its hot-pluggable SFP+ form factor allows easy installation and replacement in live network equipment. The compact design reduces slot space usage and supports interoperability with standard SFP+ interfaces, simplifying deployment in enterprise and data center environments.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and aggregation devices
• Server-to-switch high-speed connectivity in data centers
• Short- to mid-range single-mode fiber links in campus and enterprise networks
• Network equipment upgrades where hot-swappable modules are required

Key specifications

• Data rate: 10 Gbps
• Optical wavelength: 1310 nm
• Form factor: SFP+
• Interface: Duplex fiber connector (LC-type compatible)
• Application: Single-mode fiber links, short- to mid-range distances
• Hot-pluggable: Yes

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on a switch, router or server until it clicks into place. Connect an appropriate single-mode fiber patch cable (LC duplex) to the transceiver and the corresponding port on the remote device, observing the correct transmit/receive orientation. After connection, verify link status through the host device management interface and configure network settings as required. To remove the module, power down the port if recommended by the equipment vendor or use the vendor-recommended hot-swap procedure, then gently depress any release latch and pull the module straight out.

Recommendations

Use single-mode fiber with LC duplex connectors and observe manufacturer guidelines for supported link distances and environmental operating ranges. Avoid excessive bending of fiber cables, ensure clean connector end-faces before mating, and follow ESD precautions when handling the transceiver to maintain performance and longevity.