Transceptor SFP CBO ABCU-5741RZ cable de cobre 10 Gbit/s

The SFP Transceiver CBO ABCU-5741RZ Copper Wire 10Gbps is a pluggable SFP+ module for 10 Gigabit Ethernet over copper cabling. It fits standard SFP+ ports and provides 10Gbps full-duplex data transfer for compatible switches, routers and servers. The module is intended for short-reach copper links and supports hot‑swap replacement to minimize network downtime while maintaining physical layer compatibility with devices that accept SFP form-factor copper transceivers.

Advantages

This SFP+ copper transceiver offers straightforward installation and immediate compatibility with SFP+ ports, enabling rapid deployment in existing network environments using copper infrastructure. The module supports 10Gbps throughput with low latency characteristic of copper connections, and its hot-pluggable design simplifies maintenance and hardware replacement without powering down connected equipment. The compact SFP+ form factor conserves port density on network devices and reduces the need for fibre infrastructure in short-distance scenarios.

Suitable for

• Short-reach 10 Gigabit connections between switches and top-of-rack servers
• Direct copper links in data centers and server rooms
• Upgrading existing copper-based networks to 10Gbps without changing cabling type
• Hot-swap replacement or spare module stocking for network maintenance

Key specifications

• Form factor: SFP+ (10G) copper pluggable module
• Data rate: 10 Gbps full-duplex
• Media type: Unshielded or shielded twisted-pair copper (compatible with appropriate cabling)
• Range: Designed for short-reach copper links (distance depends on cable category and quality)
• Interface: Standard SFP+ electrical interface for 10GBASE-T or equivalent copper signaling
• Hot-pluggable: Yes

How to use

Power off is not required for installation; insert the transceiver into a compatible SFP+ slot on the switch, router or server until it latches. Connect the copper patch cable to the transceiver’s RJ‑45 or compatible copper interface, ensuring proper cable category and termination for 10Gbps operation. The host device should detect the module automatically and negotiate link settings. For removal, disengage the latch and pull the module straight out to avoid damaging the slot. Consult the host device documentation for any specific port configuration or firmware compatibility notes.

Recommendations

Use high-quality Category 6A or better copper cabling for reliable 10Gbps performance and reduced crosstalk. Verify that the network device firmware supports 10G SFP+ copper modules and perform link tests after installation. Keep spare modules on hand for quick replacement to maintain network uptime.