Transceptor SFP+ CBO SFP-10G-BX-D fibra óptica 10G módulo individual

SFP+ transceiver CBO SFP-10G-BX-D fiber optic 10G single-module is a compact hot-pluggable module designed to provide 10 Gigabit connectivity over single-mode fiber. The module follows the SFP+ form factor compatible with devices that accept Palo Alto Networks SFP-10G-BX-D style transceivers, enabling high-speed point-to-point or metro links. It is intended for use in switches, routers and firewalls to extend fiber links with low latency and a small footprint.

Advantages

This fiber optic 10G module offers a compact SFP+ package that supports 10 Gbps data rates while minimizing space in networking equipment. The single-module design supports single-mode fiber for long-reach links and is hot-pluggable to simplify installation and replacement without powering down the host device. The transceiver is engineered to deliver low latency and stable performance for demanding network environments.

Suitable for

• 10 Gigabit point-to-point fiber links between switches and routers
• Metro area networks and long-reach connections over single-mode fiber
• Upgrading or expanding fiber ports in firewalls and security appliances
• Data center uplinks and aggregation ports requiring SFP+ connectivity

Key specifications

• Interface: SFP+ form factor for 10 Gbps connectivity
• Fiber type: single-mode fiber (SMF)
• Data rate: 10 Gigabit Ethernet
• Connector: duplex LC-compatible or as required by host transceiver cage
• Operation: hot-pluggable module for in-service replacement
• Typical reach: designed for metro and long-reach single-mode links (see device compatibility for exact range)
• Latency: low-latency optical transmission suitable for high-performance networks

How to use

Insert the SFP+ transceiver into an available SFP+ port on a compatible switch, router or firewall until it clicks into place. Connect a single-mode fiber patch cable with the appropriate LC connectors to the transceiver. After physical installation, verify link status and configure the network interface on the host device as required by your network settings. The module is hot-pluggable, so it can be inserted or removed without powering down most compatible equipment; follow the host vendor procedures for safe removal.

Recommendations

Confirm compatibility with the host device before installation and use single-mode fiber and LC connectors that match the transceiver specifications. Use proper electrostatic discharge (ESD) precautions during handling and keep dust caps on ports when not connected to protect optical interfaces. For long-reach deployments, verify attenuation, fiber condition and link budget with appropriate testing equipment.