Transceptor SFP+ CBO SFP-10G-BX-U-40KM-CO-BO 10 Gbit/s LC monomodo 40 km

This CBO SFP+ transceiver SFP-10G-BX-U-40KM-CO-BO delivers 10 Gbit/s optical connectivity over single-mode fiber using an LC duplex interface. The compact, hot-pluggable module supports point-to-point links and long-distance uplinks up to 40 km, making it suitable for deployment in switches, routers and media converters within data centers and telecom networks. It provides a standardized SFP+ form factor for straightforward hardware compatibility and simple installation without system downtime.

Advantages

The transceiver offers 10 Gbit/s throughput with low power consumption in a small SFP+ package, enabling high-density port configurations. Hot-pluggable design reduces maintenance complexity and allows in-place upgrades. Compliance with LC single-mode optics and support for 40 km reach provide flexibility for metropolitan and campus links. The module's standardized interface supports interoperability with a wide range of network equipment.

Suitable for

• Long-distance uplinks between network switches and aggregation devices
• Point-to-point optical links in enterprise and carrier networks
• Media converters and optical line cards requiring 10 Gbit/s single-mode ports
• Data center spine-to-leaf and inter-rack connections spanning up to 40 km

Key specifications

• Data rate: 10 Gbit/s
• Fiber type: single-mode fiber (SMF)
• Optical interface: LC duplex
• Maximum reach: up to 40 km
• Form factor: SFP+ hot-pluggable module
• Typical power consumption: low-power SFP+ class

How to use

Insert the SFP+ transceiver into an available SFP+ port on a compatible switch, router or media converter until it seats and latches. Connect single-mode LC fiber cables to the transmitter and receiver ports, ensuring correct polarity. Once installed, the host device will enumerate the module and establish the optical link at 10 Gbit/s. Follow your network equipment vendor's instructions for any required interface configuration or diagnostics.

Recommendations

For reliable performance, use single-mode fiber rated for the intended distance and maintain proper connector cleanliness. Verify compatibility with the host equipment and ensure firmware or adapter settings allow third-party SFP+ modules if applicable.