Transceptor SFP+ CBO SFP-10G-ER 10G ER módulo de fibra óptica

CBO SFP-10G-ER is an SFP+ 10G ER fiber optic transceiver module designed for long-reach 10 Gigabit Ethernet links. The module provides a compact hot-pluggable interface for network switches and routers, enabling high-speed uplinks and interconnects over single-mode fiber. It supports extended reach applications in data centers, carrier networks and telecom aggregation where reliable 10GbE connectivity and low-latency performance are required.

Advantages

The transceiver offers long-distance optical transmission with a form factor compatible with SFP+ ports and hot-swappable convenience to minimize downtime during maintenance. It delivers stable 10 Gigabit Ethernet throughput and is built to interoperate with standard network equipment that accepts SFP+ optical modules. The single-mode fiber design reduces signal attenuation over long spans, while the compact metal housing provides durability and thermal stability in rack environments.

Suitable for

• Long-reach 10GbE uplinks between switches and routers
• Interconnects in data centers and server rooms over single-mode fiber
• Carrier and telecom aggregation links requiring extended reach
• High-speed backbone links in campus and metropolitan networks

Key specifications

• Interface: SFP+ hot-pluggable form factor
• Data rate: 10 Gigabit Ethernet
• Fiber type: single-mode optical fiber
• Wavelength range: long-reach (ER) optical wavelength
• Typical reach: designed for extended-distance links over single-mode fiber
• Connector: LC duplex compatible
• Operating environment: suitable for standard telecom rack and data center temperatures

How to use

Insert the SFP+ transceiver into an available SFP+ slot on a compatible switch or router while the device is powered on or off, following the host equipment manufacturer’s guidance for hot-plugging. Connect LC duplex single-mode fiber patch cables to the module, observing correct transmit/receive orientation. After physical connection, verify link status in the host device’s management interface and configure the port for 10GbE operation if required. Monitor link indicators and status messages to confirm stable operation and replace the module only when the link is inactive or as directed by maintenance procedures.

Recommendations

The module should be used with single-mode fiber and LC duplex patch cords. Ensure compatibility with the host device’s SFP+ port and check port configuration for 10GbE settings. Avoid excessive bending of fiber cables and maintain clean connector endfaces to prevent signal degradation. Follow standard electrostatic discharge (ESD) precautions when handling the transceiver.