Transceptor SFP+ CBO SFP-10G-ER 10G fibra óptica LC – puerto único 10Gb/s, conector macho LC

SFP+ transceiver CBO SFP-10G-ER 10G fiber optic LC is a single-port 10 Gigabit Ethernet module designed for long-reach fiber links. The compact, hot-pluggable module fits SFP+ slots in switches, routers and servers and provides a single LC connector for duplex fiber connections. It supports 10 Gb/s data rates for high-bandwidth uplinks and is intended for metro, campus and data center fibre runs where extended reach is required.

Advantages

The module offers a compact form factor and hot-pluggable convenience for quick installation and replacement without powering down equipment. Its single-port 10 Gb/s operation and LC connector compatibility make it suitable for common fiber infrastructures. Designed for long-reach fiber links, it enables high-bandwidth connections between network devices while conserving rack space.

Suitable for

• Long-reach uplinks between switches and routers
• Campus and metro fiber links
• 10 Gigabit Ethernet connections in data centers
• Servers and network devices with SFP+ slots requiring LC fiber interfaces

Key specifications

• Interface: SFP+ form factor, single-port
• Data rate: 10 Gb/s
• Connector: LC duplex
• Application: long-reach fiber links for uplinks and interconnects
• Compatibility: designed for use in switches, routers and servers with SFP+ slots

How to use

Insert the SFP+ transceiver into an available SFP+ slot on the network device until it seats securely. Connect a duplex LC fiber cable to the module's LC connector, observing correct transmit/receive orientation. Ensure the connected device is configured for 10 Gb/s operation and verify link status in the host device management interface. The hot-pluggable design allows installation or replacement without powering down compatible equipment, but follow your organization's change control procedures when performing live swaps.

Recommendations

Use quality single-mode fiber suitable for long-reach links and maintain clean LC connector endfaces to ensure reliable performance. Verify transceiver firmware and device compatibility with the network equipment vendor guidance before deployment. For critical links, monitor link status and consider redundant paths to maintain connectivity.