Transceptor SFP+ CBO SFP-10G-ER-1310 10G 1310 nm

The BlueOptics SFP+ Transceiver CBO SFP-10G-ER-1310 is a hot-pluggable optical module that supports 10 Gbps data transmission over single-mode fiber at a wavelength of 1310 nm. Designed for insertion into SFP+ ports, this transceiver enables long-reach links suitable for data center uplinks, metro aggregation and carrier-class networks. The module conforms to 10G SFP+ form factor expectations and provides a single-fiber interface for reliable optical connectivity in point-to-point links.

Advantages

This SFP+ transceiver delivers stable 10 Gbps throughput with low power consumption and compact SFP+ compatibility, enabling flexible port usage in switches and routers. Its 1310 nm optical profile is optimized for long-reach single-mode fiber spans, helping to maintain signal integrity over extended distances. The module’s hot-pluggable design reduces maintenance downtime and simplifies upgrades or replacements in live networks.

Suitable for

• Data center uplinks and server-to-switch connections
• Metro network aggregation and long-haul point-to-point links
• Carrier networks and service provider backbone segments
• Fiber-based enterprise campus backbones requiring 10G links

Key specifications

• Data rate: 10 Gbps
• Optical wavelength: 1310 nm
• Fiber type: single-mode fiber (SMF)
• Form factor: SFP+ (hot-pluggable)
• Typical application: long-reach optical links (extended reach)
• Interface: duplex LC optical connector compatibility

How to use

Insert the BlueOptics SFP-10G-ER-1310 module into any compatible SFP+ slot on a switch, router or network interface card while the device is powered on or off, following vendor guidance for handling ESD-sensitive components. Connect single-mode fiber using LC connectors to the module’s optical ports, ensure proper fiber routing and secure connections. Configure the network device to recognize the 10G SFP+ port and verify link status through the device management interface or LEDs. Monitor optical power and link diagnostics as supported by your hardware to confirm stable operation.

Recommendations

Use this transceiver with single-mode fiber and-rated cabling for long-reach links, and verify compatibility with your switch or router vendor’s supported transceiver list. Maintain clean LC connectors and observe ESD precautions during installation. For reliable performance, confirm that your network equipment firmware supports SFP+ modules and enable any required port settings for 10G operation.