Transceptor SFP+ CBO SFP-10G-RJ45 Módulo Ethernet de cobre 10G

CBO SFP-10G-RJ45 is an SFP+ transceiver module designed to provide 10 Gigabit Ethernet connectivity over standard copper cabling with an RJ45 connector. Intended for use in SFP+ ports, this module delivers short-range, low-latency network links between switches, servers and network appliances, allowing migration to 10G infrastructures without replacing existing copper cabling in many environments. The module is suitable for data centers and enterprise networks where reliable 10G copper links are required.

Advantages

The SFP+ Transceiver CBO SFP-10G-RJ45 offers compact form-factor compatibility with SFP+ slots while supporting 10G data rates over Cat6/Cat6a cabling. Its RJ45 interface simplifies integration into existing copper-based network topologies and reduces the need for fiber conversion equipment for short-distance connections. The module is designed for interoperability with standard SFP+ ports and aims to deliver low latency and stable throughput for server-to-switch and switch-to-switch links.

Suitable for

• Short-range 10 Gigabit links within racks and between adjacent racks
• Server uplinks to 10G-capable switches
• Edge switches and aggregation points in enterprise networks
• Data center patching where copper cabling is available

Key specifications

• Interface: SFP+ form factor with RJ45 copper connector
• Data rate: 10 Gigabit Ethernet (10G)
• Cabling: Compatible with Cat6/Cat6a (short-range 10G copper)
• Latency: Designed for low-latency operation suitable for server and switch interconnects
• Operating environment: Typical data center/enterprise temperature ranges for transceiver modules

How to use

Insert the SFP+ Transceiver CBO SFP-10G-RJ45 into a compatible SFP+ port on your switch, server or network appliance until it latches. Connect the RJ45 end to your copper cable and ensure the cable and switch port support 10G operation. Verify link status through the network device management interface and configure interface settings as required by your network (speed, duplex if applicable and any link aggregation or VLAN settings). For safe handling, follow ESD precautions and avoid applying excessive force when seating or removing the module.

Recommendations

Use certified Cat6a or higher cabling for reliable 10G performance at typical short-reach distances. Check the host device compatibility list and firmware requirements for SFP+ copper modules. For longer runs or environments requiring optical isolation, consider fiber SFP+ alternatives.