Bomba sumergible Renkforce 1034028, 1300 W, hasta 25.000 l/h

The Renkforce 1034028 submersible pump is a 1300 W electric unit designed for high-flow water transfer with a maximum capacity of up to 25,000 l/h. Built for outdoor and utility use, it handles tasks such as draining ponds, emptying pools, removing water from flooded areas and supporting irrigation or water circulation systems. The pump is intended for continuous operation where robust and reliable water movement is required.

Advantages

This submersible pump delivers a high flow rate while maintaining stable performance under load. The 1300 W motor provides sufficient power for rapid water removal and continuous operation. The pump’s construction allows it to be submerged safely, and it is suitable for a variety of outdoor water management tasks. Design choices focus on effective water throughput and practical handling for installation and relocation.

Suitable for

• Draining ponds and garden water features
• Emptying swimming pools and hot tubs
• Removing water from basements and flooded outdoor areas
• Irrigation and circulation in garden and utility systems

Key specifications

• Power input: 1300 W
• Maximum flow rate: up to 25,000 litres per hour
• Type: submersible electric pump for water transfer
• Suitable medium: clean or slightly dirty water (no large solids)
• Operating mode: continuous duty capability
• Typical installation: submerged in water for pumping or drainage

How to use

Position the pump fully submerged in the water to be removed on a stable surface, ensuring it stands upright and is not resting on loose debris. Connect the power supply according to local safety regulations and verify that any float switch or control device (if present) is free to move. Start the pump and monitor initial operation to ensure steady flow and correct discharge. When pumping is complete, disconnect power before removing the unit from the water and allow it to cool before handling or storing.

Recommendations

For reliable operation, avoid pumping large solids or heavily contaminated water; remove major debris before submerging the pump. Ensure electrical connections are protected from moisture and follow local regulations for outdoor electrical equipment. Regularly inspect the impeller area and inlet screen for blockages and clean as necessary to maintain optimal flow performance.