Cable alargador 4-Pin delgado ProXtend M4EXS-015W 15 m Blanco

ProXtend M4EXS-015W is a 4-pin slim extension cable in white, 15 meters long. Designed to extend low-voltage 4-pin connections, it provides a slender profile suited for installations with limited space. The cable preserves continuity of signal and power for compatible LED strips, controllers and other four-pin devices while allowing flexible routing and placement over longer distances.

Advantages

The slim construction reduces bulk behind panels and inside channels, enabling neat installations where thicker cables would be difficult to fit. A 15 m length allows placement of LED strips or controllers at a distance from the power source or control unit without needing multiple connectors. The white finish blends with light-coloured surfaces and helps keep the installation visually discreet.

Suitable for

• Extending 4-pin low-voltage LED strip connections
• Connecting remote controllers to LED installations
• Routing cables through narrow channels or behind trim
• Temporary or permanent low-voltage audiovisual wiring

Key specifications

• Conductor configuration: 4-pin (4 conductors)
• Cable length: 15 m
• Colour: white
• Profile: slim / low-profile cable jacket
• Intended voltage: low-voltage applications (LED and controller connections)
• Weight: 0.02 kg

How to use

Connect one end of the ProXtend 4-pin slim extension cable to the existing 4-pin connector on the LED strip, controller or device and attach the other end to the corresponding mating connector. Ensure pin alignment and secure physical connection before applying power. Route the cable along the desired path, avoiding sharp bends and pinched sections. For longer runs, check signal and power at the far end after installation to confirm correct operation.

Recommendations

For reliable performance, use this cable only in compatible low-voltage 4-pin systems and verify connector polarity before powering the circuit. Avoid exposure to excessive heat, direct sunlight or mechanical damage; secure the cable with clips or adhesive channels where necessary to prevent strain on connectors.